Technical Note: 20011004043

Metrologic Orbit 7120 Serial Scanner Setup on JS170

(Maitre'D 2002, and later versions of Maitre'D)

Note: On the JS170 the on board MSR can only be a Keyboard Wedge (KBW) device. A KBW scanner WILL NOT RELIABLY OPERATE with a second KBW device (MSR). If you use the MSR on the JS170 then any scanner added MUST be serial to get continuously reliable scanning.

METROLOGIC 7120-41 (serial)

DO NOT USE Metrologic's MetrOPOS OPOSInstall.exe file.
Instead, use the codes provided below,
or obtain the OPOS ORBIT Config.rtf document from Metrologic at; http://www.metrologic.com/

Note: Right click in this window to print this document.

Setup OPOS

Step	Bar code description	Bar Code
1	Enter / Exit program mode	999999
2	Recall Defaults	999998
3	Enable RS232	415554
4	Enable LF	116612
5	Configuration Code #1	80752020
6	Configuration Code #2	807820
7	Configuration Code #3	80791330
8	Configuration Code #4	815980
10	Configuration Code #5	8166480
11	Configuration Code #6	8184120
12	Configuration Code #7	850610
13	Configuration Code #8	85101920
14	Configuration Code #9	85111860
15	Enter / Exit program mode	999999
16	Power the scanner off and on

Program Scanner

Use the MetroSelect Configuration Guide® that comes with the unit to scan the following bar codes:

Step	Bar code description	Bar Code	Page
1	Enter / Exit configuration mode	999999	E1
2	Enable STX prefix	116615	E8
3	Enable C prefix	105511	E12
4	Enable CR suffix	116613	E14
5	Disable LF suffix	116602	E14
6	Disable ACK / NAK	115903	G9
7	Enter / Exit configuration mode	999999	E1
8	Power the scanner off and on

P.O.S. Control / Workstation / Option / Device

Type:

Select Serial.

Port:

Select the serial port of the scanner.

Note: The scanner cannot share this serial port with another device.

Driver:

Select Generic.