Technical Note: 20050309005

EPSON DM-D110 Pole Display

General Information:

Note: This document is a complement to additional information covered in the DM-D110 installation manual and support documentation.

This Pole display was tested and approved for use with the Maitre'D system. The pole display can be connected directly to a serial port with a custom serial cable (please see cable wiring diagram).

Technical Information:

The DM-D110 has dip switch settings to be aware of. The dip switch bank can be accessed on the rear top left corner of the pole display by removing the rubber cover. Maitre'D default settings are as follows:

DSW1 No	Function	ON	OFF	MAITRE'D SETTING
1	Data receive error	Ignored	Displays ???	OFF
2	Data Length	7 bits	8 bits	OFF
3	Parity On / Off	Parity	No parity	OFF
4	Parity type	Even	Odd	OFF
5	Transmission Speed	Maitre'D settings for 9600 bps	ON
6
7
8	Self Test Selection	Perform self test	Do not perform	OFF

Note: Whenever you manipulate dip switches, make sure to first turn off the power. The pwer switch is located under the pole display. Pole Display Cable Pin Out for direct connection to a com port on the host PC is as follows:

DB9 Female to Host PC	DB9 Male to Pole Display
Pin 1 Connected to	Pin 1
Pin 2 Connected to	Pin 2
Pin 3 Connected to	Pin 3
Pin 4 (Jumped With Pin 6 of Host PC)	Pin 4 (Not Connected)
Pin 5 Connected to	Pin 5
Pin 6 (Jumped With Pin 4 of Host PC)	Pin 6 (Not Connected)
Pin 7 (Jumped With Pin 6 of Host PC)	Pin 7 (Not Connected)
Pin 8 (Jumped With Pin 6 of Host PC)	Pin 8 (Not Connected)
Pin 9 (Not Connected)	Pin 9 (Not Connected)

Maitre'D settings for the DM-D110

P.O.S. Control / Workstation / Options / Devices

Type:

Select Serial.

Port:

Select the serial port of the line display.

Note: The line display cannot share this serial port with another device.

Driver:

Select EPSON ESC / POS

P.O.S. Control / Revenue Center / Options / Options

Show Subtotal on Line Display:

Enabled