Technical Note: 20011004147

Toshiba TP5660 TouchPOS Setup

(Maitre'D 2002-2003)
This unit is a serial Elographic touch screen using COM3 int 10 for touch screen. Because it uses com3 for touch screen, you must install the Elodev program release 1.7 or higher as elodev.tx.
To make it work properly under Maitre'D, you will need to make the following changes:

  1. The default network card address and IRQ for this terminal is added. 300 int. 5. You need to edit the C:\POSERA\MAITRE'D\PRG\POSNET\Protocol.ini file with these parameters.
  2. Modify the ELODEV configuration key and value in C:\POSERA\MAITRE'D\PRG\AUTOELO.TX file to read:

lh ELODEV 2210,3,9600,10

After you made these changes, create a workstation disk as Elographic workstation type.
  1. This workstation uses an external floppy that you connect at the back of the terminal. If you want to boot directly on the hard drive, you must put system files from Ms DOS 6.2.
Edit From the floppy disk to change all paths form a:\ to C:\ and copy the boot disk on the CD drive.
NOTE:After any update of the Maitre'D software, you will need to redo all this procedure before you can do a workstation LAN disk again.
If you want to use Com4, you must define it as address 02E8 Int. 9